The brush holders can sometimes melt if the motor overheats. The sliding cover can only be purchased with a brush holder.
PM50 Low profile brush holder
These are rivetted onto the new PM50 73mm/2.7" diameter motors. The brush holders are attached
with 2 rivets each
£7.00 per brush holder and cover
PM50 High profile brush holder
To fit onto the
PM50 73mm/2.7" diameter motors with the old style brush holders which extend approx 25mm / 1" each side from the motor
body. They are attached with just one rivet.
£7.00 per brush holder with cover
PM63 Low profile brush holder
To fit onto the
newer PM63 90mm/3.5" diameter motors. The brush holder is attached with 2 rivets each.
£7.00 per brush holder and cover
PM63 High profile brush holder
To fit onto the
older PM63 motor 90mm / 3.5" diameter with the old style brush holders which extend approx 25mm / 1" each side from the motor
body, and are attached by only 1 rivet.
